Rockford Fosgate POWER 150 Operation & Installation page 2

S
P E C I F I C AT I O N S
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4 Volts
Mono into a 4Ω Load
Mono into a 2Ω Load
Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts
RMS continuous power mono, driven into a
4Ω load from 20 to 20,000Hz with less than
0.05% Total Harmonic Distortion (THD)
RMS continuous power mono, driven into a
2Ω load from 20 to 20,000Hz, with less than
0.1% Total Harmonic Distortion (THD)
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Dimensions
Frequency Response
Bandwidth
Damping Factor @ 4Ω (at output connector )
Slew Rate
IM Distortion (IHF)
Source Unit Compatibility (+15dB gain overlap)
Input Sensitivity (+0dB gain overlap)
Protection
Battery Fusing Rates (External to Amplifier)
Fuse Type
Equalization (45Hz Punch Bass)
Input Impedance
NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
Specifications are subject to change without notice.
POWER 150
110 Watts
190 Watts
75 Watts
150 Watts
>100dB A-weighted
12dB/octave Butterworth
variable from 50Hz to 210Hz
2.60" (6.60cm) H
9.60" (24.38cm) W
6.70" (17.01cm) L
20Hz to 20kHz ±0.5dB
10Hz to 200kHz ±3dB
17V max. (low level in)
Variable from 250mV to 4V (low level in)
Variable from 650mV to 11V (high level in)
15 amps
ATC
Variable from 0dB to +18dB @ 45Hz
– i –
POWER 200
150 Watts
260 Watts
100 Watts
200 Watts
2.60" (6.60cm) H
9.60" (24.38cm) W
7.70" (19.55cm) L
>200
30 Volts/µs
<0.05%
20 amps
ATC
20k ohms