Door Control - Secura Key ENTRACOMP 28SA Plus User & Installation Manual

DOOR CONTROL

DOOR UNLOCK MODE
The relay may be set to remain latched (door unlocked) during periods when
access control is unwanted. While in the "DOOR UNLOCK" mode, the relay
stays activated and the LED indicator will flash green, approximately once
every second. The unit cannot be programmed with the Programming Deck and
it will not recognize Access Cards while it is in the "DOOR UNLOCK" mode.
To set the unit to the "DOOR UNLOCK" mode, place the "
®
TOUCH CARD
To return the ENTRACOMP
INACTIVE" card on the TOUCH CARD
INACTIVE MODE
The ENTRACOMP
cardholders. While the unit is in the "INACTIVE" mode the red LED indicator will
flash approximately once every second. While in the "INACTIVE" mode the
unit cannot be programmed with the Program Deck and it will not recognize
any Access Cards.
To place the unit in the "INACTIVE" mode place the "ACTIVE/INACTIVE" card
on the TOUCH CARD
reader plate followed by the "ACTIVE/INACTIVE" card
Place unit in Door Unlock mode.
+
*
®
28SA-PLUS to normal operation, place the "ACTIVE/
Return to Normal Mode.
ACTIVE/INACTIVE
®
28SA-PLUS may be made inactive, locking out all
®
reader plate. To restore the unit to normal operation,
ACTIVE/INACTIVE
®
reader plate.
37
" (THRU) card on the
*