Connecting An External Power Amplifier - Yamaha RX-A1010 Owner's Manual

1 2 3 4 5 6 7 8
Speaker connections
■

Connecting an external power amplifier

When using an external power amplifier to enhance speaker output, connect the input
jacks of the power amplifier to the PRE OUT jacks of this unit. The same channel signals
are output from the PRE OUT jacks as from their corresponding SPEAKERS terminals.
Caution
• To prevent the generation of loud noises or abnormal sounds, make sure the followings before making
connections.
- Remove the power cable of this unit and turn off the external power amplifier before connecting them.
- When using the PRE OUT jacks, do not connect speakers to the corresponding SPEAKERS
terminals.
- When using an external amplifier that does not have the volume control bypass, do not connect other
devices (except this unit) to the amplifier.
This unit (rear)
HDMI RS-232C
AV 2 AV 3 AV 4 AV 5 AV 6 AV 7
ONENT VIDEO TRIGGER
Y AV 3 P B C P R OUT
1
REMOTE
MONITOR OUT/ZONE OUT
Y P P
B R IN OUT
2
AV 4 D +12V 0.1A MAX.
TI CH INPUT
CENTER ZONE OUT PRE OUT (SINGLE)
1
2
ND SUR. BACK SUBWOOFER ZONE 2 FRONT SURROUND SUR. BACK SUBWOOFER CENTER
SPEAKERS
SURROUND SURROUND BACK CENTER FRONT ZONE 2/F.PRESENCE/
R L R L R L R
BI–AMP
EXTRA SP
SINGLE
1 2 3 4
1
FRONT jacks
Output front channel sounds.
2
SURROUND jacks
Output surround channel sounds.
3
SUR. BACK jacks
Output surround back channel sounds. When using only one external amplifier for the surround
back channel, connect it to the SINGLE jack (L side).
4
CENTER jack
Outputs center channel sounds.
AC IN
L
(Example)
Connecting front speakers via an external power amplifier
PRE OUT (FRONT) jacks
MI RS-232C
AV 4 AV 5 AV 6 AV 7
TRIGGER
OUT
1
MONITOR OUT/ZONE OUT REMOTE
P B P R
IN OUT
PR
2
+12V 0.1A MAX.
PRE OUT
(SINGLE)
1
L
2
FRONT SURROUND SUR. BACK SUBWOOFER CENTER R
SPEAKERS
AC IN
SURROUND BACK CENTER FRONT ZONE 2/F.PRESENCE/
L R L R L
BI–AMP
EXTRA SP
FRONT SUR
SINGLE
This unit (rear)
About external power amplifiers
We recommend using power amplifiers that meet the following conditions.
- With unbalanced inputs
- With volume control bypass (or without volume control circuit)
- Output power: 100 W (8Ω) or more
• When using an external amplifier that does no have the volume control bypass, turn up the volume of the
external amplifier enough and fix it.
Main input jack
MAIN IN
L
R
Amplifier with
volume control
bypass
(A-S2000, etc.)
23
En