Updating The Firmware Of This Unit - Yamaha RX-A1010 Owner's Manual

MAIN MAIN ZONE 2 ZONE 2
CODE SET CODE SET
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
MULTI MULTI PHONO PHONO DOCK DOCK
TUNER TUNER SIRIUS SIRIUS NET NET USB USB
CATEGORY CATEGOR A A Y
FM FM AM AM
PRESET PRESET TUN./CH TUN./CH
INFO INFO MEMORY MEMORY
SUR. DECODE STRAIGHT SUR. DECODE STRAIGHT
MOVIE MOVIE MUSIC MUSIC
SLEEP SLEEP PARTY ENHANCER ENHANCER ENHANCER P PURE DIRECT URE DIRECT
SCENE SCENE
1 1 2 2 3 3 4 4
BD/DVD BD/DVD TV TV CD CD RADIO RADIO
ON SCREEN ON SCREEN OPTION OPTION
Cursor keys
ENTER VOLUME VOLUME
ENTER
RETURN RETURN DISPLAY A A DISPLAY
TOP TOP POP-UP POP-UP
MUTE MUTE
MENU MENU MENU MENU
MODE MODE
HOLD TAG PRG SELECT
1 1 2 2 3 3 4 4
5 5 6 6 7 7 8 8
9 9 0 0 10 10 ENT ENT
TV
INPUT INPUT
TV VOL TV CH
HDMI OUT
MUTE MUTE

Updating the firmware of this unit

If this unit is connected to the Internet, the corresponding message
will be displayed on the TV when a newer firmware is available. In
this case, follow the procedure below to update the firmware of this
unit.
Note
• Do not operate this unit or disconnect the power cable or network cable during
firmware update. Firmware update takes about 15 minutes.
• You can also update the firmware using the USB memory device from the
"ADVANCED SETUP" menu (p.120).
If the following message is displayed after ON SCREEN is pressed,
firmware update is available.
1
Read the on-screen description.
2
To start the firmware update, use the cursor keys to
select "START" and press ENTER.
The on-screen display turns off.
3
If "UPDATE SUCCESS PLEASE POWER OFF!"
appears on the front display, press MAIN ZONE
on the front panel.
The firmware update is complete.
• If you want to update the firmware later, select "CLOSE" in step 2. In this
case, "!" (exclamation mark) appears at the upper right of the "Information"
and "System" icons, and the corresponding message will be displayed in the
"System" screen (p.117). You can update the firmware of this unit by
pressing ENTER in the "System" screen.
Information
icon
Message
System icon
124
En