Advertisement
Use a
( - 1
screwdriver to lower the three
(-1
screws by turning rightward
( - )
screws on
the base
(see
right).
Use
a
square or ruler to obtain the desired
base angle in relation to the diamond wheel.
Then secure carefully the hex socket head
bolts on either side of the base. Adjust
center of base near wheel so that
it i s
on
the same
level as
the wheel.
Note: After base adjustment, turn
3
( - 1
screws leftward on base until the
heads are flush with the back side
of the base. Turn gently or base
adjustment will be thrown off.
Same line (level)
Base adjustment
to
compensate for wheel wear
With long use, the diamond wheel will wear and thus create a gap with the planing surface
so
that performance becomes poor. Check the tool after every 4 or 5 hours of use. If the
wheel and base surfaces are not alignend, loosen the hex socket head bolts securing the
base. Turn the
( - 1
screws on the base to the right and adjust the base
so as
to be level
with the wheel surface. Retighten the bolts and then gently ease the
( - 1
screws to the
left until flush with the back side
of
the base. The screws should not come loose during
operation.
Planing in corners
Flush planing of corners i s possible after first removing the dust cover.
Turn dust cover rightward until it stops, light toward you t o remove.
I
Dust
cover
7
Advertisement
