Advertisement
How touse
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. Model with a
lock button on the handle may be run con-
tinuously without keeping your finger on
the trigger. To lock the trigger in the ON
position first pull the trigger and then de-
press the lock button on the handle with
your thumb.
To stop the tool from the
lock position, just pull the trigger again and
release it.
To change the amount of stock (concrete)
removed, loosen the hex socket head bolts
on the grip holder with the hex wrench.
Raise or lower the front roller to adjust the
gap between it and the diamond wheel. The
difference is the stock removal amount.
Then secure the hex socket head bolts very
carefully.
Note: Maximum stock removal should be
less than 2.5 mm (3/32").
I
I
Hex socket
I
Stock removal amount
I
Tilting base for smoother
planing
For smooth removal of
a
given surface
roughness or texture, tilting the base i s
helpful. Use the hex wrench to loosen the
two hex socket head bolts securing the
base on either side.
6
Advertisement
