Firmware Renewal Mode - Onkyo BD-SP808BCDC1N Service Manual

Note: The file extension of the available firmware is
"b35".
1. Turn the power on and remove the disc on the tray
and close the tray.
2. To put the BD player into version up mode, press
[9], [8], [7], [6], and [POP UP MENU/MENU]
buttons on the remote control unit in that order.
The tray will open automatically.
Fig. a appears on the screen and Fig. b appears
on the VFD.
" ******* " differs depending on the models.
F/W VERSION UP MODE
Please Insert a Disc
for F/W Version Up
Fig. a Version Up Mode Screen
Fig. b VFD in Version Up Mode
3. Load the disc for version up.
4. The BD player enters the F/W version up mode
automatically. Fig. c appears on the screen and
Fig. d appears on the VFD. Make sure to insert the
proper F/W for the state of this model.
" ******* " differ depending on the models.
F/W VERSION UP MODE
(*1) Now Loading...
Fig. c Programming Mode Screen (Example)
Fig. d VFD in Programming Mode (Example)

FIRMWARE RENEWAL MODE

F/W Name: ******* Ver. *.***
F/W Name: ******* Ver. *.***
The appearance shown in (*1) of Fig. c is
described as follows:
No. Appearance
1 Now Loading... Loading the disc
2 Reading...
3 See FL Display.
" ******* " differ depending on the models.
F/W VERSION UP MODE
1. ALL
Version : *.***
CHECKSUM : ****
See FL Display.
Fig. e Version Up Mode
Fig. f VFD in Version Up Mode
5. After programming is finished, the checksum on
the VFD (Fig. g).
Fig. g VFD upon Finishing the Programming Mode (Example)
Checksum appears on the VFD then the tray will
open automatically. Remove the disc on the tray.
At this time, no button is available.
6. Unplug the AC cord from the AC outlet. Then plug
it again.
7. Turn the power on.
Note: All the settings will be put back to factory-
default.
1-7-1
State
Sending files into the
memory.
Writing new version data,
the progress will be displayed
as shown in Fig. f.
F/W Name: ******* Ver. *.***
**************.b35
EXIT : POWER
E5SE0FW