MTD H Style 600 Series Operator's Manual page 16

Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers
and the flange bearings found at either end of the shaft.
See Fig. 6-3.
16 s 6— M
ectiOn aintenance
Figure 6-3
& a
djustMents
Adjustments
Chute Bracket Adjustment
If the spiral at the bottom of the chute directional control is not
fully engaging with the chute assembly, the chute bracket can be
adjusted. To do so:
1. Loosen the two nuts which secure the chute bracket and
reposition it slightly. See Fig. 6-4.
Figure 6-4
Retighten the nuts.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.