Table of Contents
Advertisement
SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: This Operator's Manual covers several models.
Snow thrower features vary by model. Not all
features discussed in this manual are applicable to all
snow thrower models.
Unpacking From Carton
•
Cut along corners of the carton and lay it down flat.
Remove packing material.
•
Remove any loose parts included with unit (i.e.,
operator's manual, etc.).
•
Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
Items Required For Assembly
1. Engine oil
2. Fresh gasoline
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
Before Assembly
WARNING:
Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting. Refer to the separate
engine manual packed with your unit.
Raising Upper Handle
•
Loosen the hand knob on each side of the handle.
Remove packing material, if any.
Figure 1
•
•
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way
down as shown in Figure 2. To pivot it upward, proceed
as follows:
1. Turn the chute until the chute opening is facing
2. Remove the wing knob, flat washer and carriage
3. Pivot the upper chute upward over the lip on the
4. Resecure with the hardware just removed.
Hand Knob
Spark Plug
Access
5
Raise the upper handle in the direction shown in
Figure 1 until it clicks into the operating position.
Make sure not to pinch or crimp the cable.
Tighten the hand knobs.
straight ahead.
bolt from the lower chute.
lower chute so that there is NO gap between the
upper chute and the lower chute.
CAUTION: Do not use the Chute
Handle to lift the machine.
3
1
Figure 2
4
2
Advertisement
Table of Contents
