Hardware Pack - MTD 644E Operator's Manual

SECTION 2: CONTENTS OF HARDWARE PACK
Lay out the hardware according to the illustration below for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
A
ATTACHING THE HANDLES
Hex Bolts
710-04039 (2)
Hex Bolts
710-1880 (2)
C
ATTACHING CHUTE DIRECTIONAL CONTROL
Cupped Washer
736-0242
Flat Washer
736-0185 (1)
F
ATTACHING CHUTE ASSEMBLY
Hex Bolts
710-3015 (2)
NOTE:
The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign
object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed.
Lock Washers
736-0119 (4)
Saddle
784-5599 (2)
Eyebolt (Not Shown)
747-0697
Hex Nuts
712-3010 (2)
Hairpin Clip
714-0104
Hex Lock Nuts
712-3027 (6)
Chute Flange Keepers
731-0851A (3) Not Shown
(Boxed Units)
B
ATTACHING HANDLE PANEL
Carriage Bolts
710-0262 (4)
Hex Patch Nuts
712-3068 (4)
D
ATTACHING CLUTCH CABLES AND SHIFT ROD
(Z Fittings might be already attached to cables)
Z Cable Fitting
746-0778 (2)
Ferrule
Hairpin Clips
711-0677
714-0104 (2)
E
ATTACHING THE CLUTCH GRIPS
Hex Screws
710-3103 (2)
G
REPLACEMENT SHEAR BOLTS
Hex Lock Nuts
712-0429 (2)
5
Cupped Washers
736-0242 (4)
Jam Nuts
712-0121 (2)
Flat Washers
736-0275 (2)
Spacer
750-1032 (2)
Hex Top L-Nut
712-0429 (2)
Hex Bolts
710-0890A (2)