Main Frame Assembly-Part4; Landing Skid Assembly - THUNDER TIGER Raptor 50 V2 kit Manual

9 Main Frame Assembly-Part4

Add blue Loctite to all metal to metal screw surfaces.
After installing the engine, connect the silicone fuel tube
to the carburator and muffler.
(1) HMC3-14B Socket Screw(M3x14)...... 8
(2) HMC3-35B Socket Screw(M3x35)..... 2
(3) BK0087 Flat Washer ........................... 4
(4) BK0144 Engine Mount........................ 1
(5) BV0172 Muffler ................................... 1
(6) Engine Assembly
(7) BA1579 Muffler Gasket.......................
(8) BK0179 Spacer...................................
Engine Mount Notes:
The engine mount furnished will accommodate the Thunder Tiger 46H,
50H, and the other heli engines. If you are installing a Thunder Tiger
engine, you will find the mount is wider than the engine crankcase. Two
spacers are furnished to accurately locate the engine while bolting it in
place. Remove these spacers after installation.
Step1
Step2
Install the engine and
Install the 4 mount screws
spacers into the engine
and make sure the screws
mount.
are tightened firmly.

10 Landing Skid Assembly

(1) HSE3-18B Self Tapping Screw(M3x18).4
(2) HME4-5B Set Screw(M4x5)..................4
(3) BK0066 Skid Brace...............................2
(4) BK0064 Skid Pipe.................................2
(5) BK0065 Skid Pipe End Cap..................4
(6) BK0525 Carbon Base Plate..................1
1
2
(3) BK0087
(1) HMC3-14B
Add Blue Locktite
(3) BK0087
(6) Engine Ass'y.
Step3
Remove the spacers.
(5) BK0525
(3) BK0066
(1) HSE3-18B
(2) HME4-5B
(5) BK0065
(4) BK0144
(1) HMC3-14B
(2) HMC3-35B
Add Blue Locktite
(8) BK0179
10
(3) BK0087
(1)
HMC3-14B
Add Blue
Locktite
(3) BK0087
(5) BV0172
(7) BA1579
Engine mount
Attachment
(2) HME4-5B
(3) BK0066
(2) HME4-5B
(4) BK0064
(1) HSE3-18B
(5) BK0065