Toshiba RAV-SM562CT-E Installation Manual page 26

8
APPLICABLE CONTROLS
Procedure example
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
Procedure
Push simultaneously
shown below. Check the displayed CODE No. is [10].
• When the CODE No. is other than [10], push
erase the display and repeat procedure from the first step.
1
(After pushing
is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed indoor unit
becomes the header unit.)
Every pushing
unit of which setup is changed.
2
In this time, the position of the indoor unit of which setup is changed can be confirmed because fan and louver
of the selected indoor unit operate.
Using temp. setup
3
-1 CODE No. [12]. (CODE No. [12]: Line address)
Using timer time
3
-2 from [3] to [2].
SET
Push button.
3
-3 In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
4
-1 CODE No. [13]. (CODE No. [13]: Indoor address)
Using timer time
4
-2 from [3] to [2].
SET
Push button.
4
-3
In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
5
-1 CODE No. [14]. (CODE No. [14]: Group address)
Using timer time
5
-2 [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit: 0002])
SET
Push button.
5
-3
In this time, the setup finishes when the display changes from
flashing to lighting.

Manual address setup procedure
3 4
-2, -2,
SET CL TEST
+ + buttons for 4 seconds or more. After a while, the display part flashes as
TEST
button, operation of the remote controller
UNIT LOUVER
button, the indoor unit No. in the group control is displayed in order. Select the indoor
/ buttons, specify
/ buttons, change the line address
/ buttons, specify
/ buttons, change the indoor address
/ buttons, specify
/ buttons, change the setup data from
TEMP.
5
-2
TIMER SET FAN
7
TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX
1
Description
TEST
button to
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
23
7
ON / OFF
3 4
-1, -1,
MODE
2 6
VENT
,
UNIT LOUVER
3 4
-3, -3,
∗
( Display changes according
to the model No. of indoor unit.)
5 6
-1,
5
-3