Toshiba RAV-SM562CT-E Installation Manual page 17

Wire connection
• Be sure to connect the wires matching the terminal numbers. Incorrect connection causes a trouble.
• Be sure to pass the wires through the bushing of wiring connection port of the indoor unit.
• Keep a margin (Approx. 100mm) on a wire to hang down the electric parts box at servicing, etc.
• The low-voltage circuit is provided for the remote controller. (Do not connect the high-voltage circuit)
• Loosen the cover mounting screws (2 positions) of the electric parts box, and then remove the cover.
• Slit the film of bushing attached to the power take-in port and remote controller wire take-in port, and then pass
through wires.
• Connect the indoor/outdoor connecting wires and the remote controller wire to the terminal block of the electric
parts box.
• Tighten screws of the terminal block securely, and fix the wires with code clamp attached to the electric parts
box. (Do not apply tension to the connecting section of the terminal block.)
• Mount the cover of the electric parts box so that it does not pinch the wires.
REQUIREMENT
Two screws
Electric parts box
P.C. board
14
Terminal block