Power Windows - Mercedes-Benz SL 320 Operator's Manual

Press switch past resistance point
and release - window lowers to fully
open position. To interrupt
procedure, briefly press
or .
Warning!
When leaving the vehicle, always
remove the key from the steering
lock. Do not leave children
unattended in the vehicle.
Unsupervised use of vehicle
equipment may cause serious
personal injury.
Note:
The power windows can also be closed
with the key or infrared remote control
while locking the vehicle doors or
trunk (see Central Locking System in
Index
Synchronizing Power Windows
With ignition key in steering lock
position 2, press side of power
window switch until the window is
completely closed and hold for
additional 2 seconds. Repeat procedure
for each window.
Important!
Do not close a door with the windows
fully closed while the power supply is
interrupted (battery disconnected or
empty). Doing so could damage the
window frame.
The power windows should first be
resynchronized.
Roll Bar
The switch is located in the center
console.
Turn key in steering lock to position 2.
Press switch
Upper half = to raise
Lower half = to lower
The lowering or raising procedure is
immediately interrupted by releasing
the roll bar switch.
61