Driving Instructions - Mercedes-Benz SL 320 Operator's Manual

Driving Instructions

Power Assistance
Warning!
When the engine is not running, the
brake and steering systems are
without power assistance. Under
these circumstances, a much greater
effort is necessary to stop or steer
the vehicle.
Brakes
Caution!
When driving down long and steep
grades, relieve the load on the brakes
by shifting into "3", "2" or "B" (for
models SL 500 and SL 600). This
helps prevent overheating of the brakes
and reduces brake pad wear. Do not
exceed engine speed limits. Refer to
Technical Data for downshift points.
After hard braking, it is advisable to
drive on for some time, rather than
immediately parking, so the air stream
will cool down the brakes faster.
Warning!
After driving in heavy rain for some
time without applying the brakes or
through water deep enough to wet
brake components, the first braking
action may be somewhat reduced
and increased pedal pressure may be
necessary. Be sure to maintain a safe
distance from vehicles in front.
Resting your foot on the brake pedal
will cause excessive and premature
wear of the brake pads.
It can also result in the brakes
overheating thereby significantly
reducing their effectiveness. It may
not be possible to stop the car in
sufficient time to avoid an accident.
The condition of the parking brake
system is checked each time the car is
in the shop for the required
maintenance.
All checks and maintenance work on
the brake system should be carried out
by an authorized Mercedes-Benz
dealer.
If the parking brake is released and the
brake warning lamp in the instrument
cluster stays on, the brake fluid level in
the reservoir is too low.
Brake pad wear or a leak in the system
may be the reason for low brake fluid
in the reservoir.
Have the brake system inspected at an
authorized Mercedes-Benz dealer
immediately.
Install only brake pads and brake fluid
recommended by Mercedes-Benz.
Warning!
If other than recommended brake
pads are installed, or other than
recommended brake fluid is used,
the braking properties of the
vehicle can be affected to an extent
that safe braking is substantially
impaired.
16