Removing The Water Reservoir - KitchenAid KSSC36FKB00 Technical Education

REMOVING THE WATER RESERVOIR

Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the refrigerator or disconnect the
power.
NOTE: If the water reservoir tubing located
inside the refrigerator compartment becomes
damaged, you can cut and splice a new reser-
voir in its place using two 5/16" unions
(#4388201). If the tubing located under the
refrigerator is defective, it will be necessary to
remove the unit from its mounting location to
repair it. If that is the case, use the following
procedure.
2. Remove the two screws from the base
grille and remove the grille.
Base Grille
Screw
NOTE: The water reservoir and water valve
locations are shown below.
Water Reservoir
Screw
Leveling Screws
Unit Shown Tipped Back 45˚
4-20
3. Use the leveling screws and lower the
refrigerator onto the four rollers.
Leveling Screws
Rear
Tip Over Hazard
Refrigerator is top heavy and tips easily
when not completely installed.
Keep door taped closed until refrigerator
is completely installed.
Use two or more people to move and
install refrigerator.
Failure to do so can result in death or
serious injury.
4. Pull the refrigerator out of its mounting
location.
Water Valve
Front