Electrical Requirements; Water Supply Requirements - KitchenAid KBSD708MPS Owner's Manual

� The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the floor. See
"Water Supply Requirements" for more information.
C
Model Width A (as
shown above)
35 1 / " to 35
36 2
(90.2 cm to 90.8 cm)
411/2" to 413/4"
42
(105.4 cm to 106.1 cm)
471/2" to 473/4"
48
(120.7 cm to 121.3 cm)
NOTE: Flooring under appliance must be at same level as the
room Face of cabinetry must be plumbed.
Installation Type
Standard Flush
(new installation)
Retrofit Installations
NOTE: On retrofit installations, door panels will not be flush with
adjacent cabinets.
Dimension B (as
shown above)
3 / "
4 4" (10.2 cm)
7 1 / " (19.1 cm)
2
13 1 / " (34.3 cm)
2
Depth C (as
shown above)
25" (63.5 cm)
minimum
24" (60.9 cm)
minimum

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person.
Do not use a cord that shows cracks or abrasion damage along its
length or at either the plug or connector end.
Recommended Grounding Method
A 115 V, 60 Hz AC only 15 A or 20 A fused, grounded electrical
supply is required. It is recommended that a separate circuit
serving only your refrigerator and approved accessories be
provided. Use an outlet that cannot be turned off by a switch. Do
not use an extension cord.
IMPORTANT: If this product is connected to a GFCI (Ground Fault
Circuit Interrupter) protected outlet, nuisance tripping of the power
supply may occur, resulting in loss of cooling. Food quality and
flavor may be affected. If nuisance tripping has occurred, and if
the condition of the food appears poor, dispose of the food.
NOTE: Before performing any type of installation or cleaning,
remove the top grille and turn the master power switch to OFF or
disconnect power at the circuit breaker box. When you are
finished, turn ON the master power switch or reconnect power at
the circuit breaker box. Then reset the control to the desired
setting.

Water Supply Requirements

IMPORTANT:
� All installations must meet local plumbing code requirements.
� Connect to potable water supply only .
� There is not enough clearance to achieve a flush installation if
a water shutoff valve is located in the wall behind the
refrigerator.
� The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. The right-hand side is recommended. The access hole
through the cabinet must be within 1/2" (1.3 cm) of the rear
9