Determining Battery Condition; Installing The Driver; Using A Handheld Computer (Hhc); Compatible Handheld Computers - Datamax PrintPAD CN70 User Manual

The Charge LED flashes red when charging and flashes green when fully charged. The Charge LED is visible when the
printer's lid is open or closed. A complete charge takes approximately 7-9 hours. For more information on the Charge
PrintPAD CN70 LEDs and Indicators on page 6
LEDs, see
Note: To obtain full battery capacity, a new battery must cycle through two to three charges. To restart a charge,
unplug the power cord. Wait 30 seconds, then replug the power cord.
The CN70 Handheld Computer will charge while power is plugged into the DC power port.
Caution: Do not plug DC power into the internal and external power ports at the same time.
Do not plug the DC power supply into the printer if the printer is being charged by means of external charge
contacts.

Determining Battery Condition

You can determine the relative battery condition by printing a self-test. For more information, see
on page 5
. On the printout, "Battery Volt" varies between 6.8 and 8.4 volts.
Caution: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
The operating temperature of this portable printer is 50° C. However, the operating temperature when used with
Datamax-O'Neil power supply for charging the portable printer is limited to 40° C. Charge the printer in a suitable
location that meets this temperature requirement.
(For US/Canada) Use only the Datamax-O'Neil part number 220240-100 power supply with this product.

Installing the Driver

Note: Before using the CN70, it is necessary that the appropriate USB driver is installed. Refer to the USB
Installation Guide for more information.
1. Go to www.datamax-oneil.com and click
2. Install the driver onto the handheld computer.

Using a Handheld Computer (HHC)

1. Insert the handheld into the cavity by sliding it in from the top.
2. Press down until the handheld is fully latched and seated.

Compatible Handheld Computers

Note: The PrintPad CN70 series is intended for use with the UL Listed Accessory Handheld Computer Intermec
Technologies Corp 1000CP01 series or the UL Listed Accessory Handheld Computer Intermec Technologies Corp
1000CP02 series.
.
Support to obtain the appropriate driver for the PrintPAD CN70.
3
PrintPAD CN70 USER'S GUIDE
Printing a Self-Test