Placement Of Speakers; Making The Connections - Panasonic SC-PMX5 Operating Instructions Manual

Cd stereo system
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Placement of speakers

Place the speakers so that the tweeter is on the inner side.
To prevent damage to the speakers, do not touch the
speaker cones if you remove the nets.
Use only the supplied speakers.
The combination of the main unit and speakers give the
best sound. You can cause damage to the system and
decrease the sound quality if you use other speakers.
Note:
• Keep your speakers more than 10 mm from the main unit
for ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• When you play at high levels for a long period, it can
cause damage to the system and decrease the life of
the system.
• Decrease the volume in these conditions to prevent
damage:
– When you play distorted sound.
– When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
4
4

Making the connections

Tweeter
Conserving power
The system consumes approximately 0.4 W when it is in
standby mode. Disconnect the power supply if you do not
use the system.
Some settings will be lost after you disconnect the system.
You have to set them again.
4
1
Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
3
2
1
To household mains socket
2
Connect the FM indoor antenna.
Place the antenna where reception is best.
Tape
3
Connect the speakers.
Red (q)
Black (r)
Copper (q)
Silver (r)
Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so may
damage the speakers.
4
Connect the AC mains lead.
Do not use an AC mains lead from other equipment.
Red (q)
Black (r)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents