Warranty Service And Repair; General Product Warranty - Traxxas Stampede 3601 Operating Instructions Manual

Step 4: After the body is completely painted, remove the peel coat
from the outside of the body.
Step 5: Paint the wing on the underside. Use double-sided tape to
secure the wing to the Rustler body.
INSTALLING THE WING: (Bandit Only)
6
Step 1: Locate the wing, wing buttons,
wing wire, and two 3mm grub screws.
Paint the wing on the underside. Cut the
wing out and use a tapered reamer to
make two small 7mm holes. Use the tip of
a hobby knife to start the small holes. Do
not use a drill bit. It will tear the wing
material.
Step 2: Use masking tape to protect the
painted wing from scratches when
installing the wing wire. Cut the tape out
of the opening for the wing buttons and
push the aluminum wing buttons
through the holes.
Step 3: Carefully insert the wing wire
through the holes in the wing buttons.
Secure the wing wire by inserting the
3mm grub screws into the wing buttons,
as shown.
Step 4: Finish bending the ends of the
wing wire until they are perpendicular to
the bottom of the wing.
DECAL THE BODY:
You are now ready to apply the decals. Use scissors or a hobby knife to
trim the decals. Test the position of the decals before applying them to
the body. Once the decals have been applied, they cannot be removed
without damaging them. You can spray the body with window cleaner
before applying the decals. This will allow you to re-position them.
Once positioned, squeegee the cleaner from under the decal. The decal
will adhere when it dries. If you have air bubbles in the decals, puncture
the center of each bubble with a sharp pin and push the air out. If you
have creases along the outer edges of a decal (especially when applied
to curved surfaces), use a hobby knife to cut along the top of the crease
and overlap the edges.

WARRANTY SERVICE AND REPAIR:

Defective Merchandise Policy - Traxxas Corporation assumes
responsibility for its products and will repair or replace any defective
product at its sole discretion. Please contact Traxxas directly should a
problem arise with one of our products. Customer and dealer service
hours are from 8:30am to 9:00pm central time. Customer service can
be contacted toll-free at 1-888-TRAXXAS (1-888-872-9927), and
outside the United States at 972-265-8000. The Traxxas fax number
is 972-265-8011. Email support is available 24 hours a day at
support@Traxxas.com.

GENERAL PRODUCT WARRANTY:

Electronic Components - Traxxas electronic components are
warranted to be free from defects in materials and workmanship
for a period of thirty (30) days from the date of purchase. Electronic
components consist of the radio system (transmitter, receiver, servos,
switches, and receiver battery holders), and any other Traxxas
electronic component. See the additional limitations that apply.
Chassis and Engine - - The chassis consists of all remaining parts of
the model that are not considered electronic or part of the engine.
A Traxxas product is considered to be a race oriented, hobby-class
model. We have made every effort in component design, material
selection and assembly to make our products as durable as possible.
Because our products are high-performance hobby-class models that
operate at a much higher level of performance than a "toy," they
require periodic maintenance, and are intended to be used in high
performance applications over an extremely wide range of running
Step 5: This photo is for demonstration
only. You must install the Bandit body
before installing the wing. Insert the wing
through the holes in the body and into
the holes in the top of the shock tower.
If the wing is loose, spread the ends of the
wire out so that the wing fits tighter in
the holes.