Page 2
INTRODUCTION The Traxxas DCB M41 Widebody raises the bar for reliable, We want you to feel confident that you own one of the best- BEFORE YOU PROCEED high-performance RC boating with 50+mph speed, waterproof performing models in the market and that it is backed by a team...
Traxxas accompanying materials to prevent serious damage to your 6250 Traxxas Way All of us at Traxxas want you to safely enjoy your new model. model. Failure to follow these instructions will be considered McKinney, Texas 75070 Operate your model sensibly and with care, and it will be exciting, Phone: 972-549-3000 abuse and/or neglect.
Page 4
• Because of the many dangers involved with any body of water, This model is not intended Using mismatched battery packs could damage the batteries and Traxxas recommends that you never try to wade or swim to for use by children under electronic speed control.
Page 5
SAFETY PRECAUTIONS • Do not use battery packs that have been damaged in any way. If you as the user do not accept liability of ownership, Traxxas requests that you do not use this product. Do not open any of the •...
Page 6
Dispose of used batteries according to the instructions. This will cause the battery to short circuit and create the risk of fire. • A LiPo balance charger (such as the Traxxas EZ-Peak Dual, part #2972, • DO NOT leave the charger and battery unattended while charging, sold separately) is required to charge the batteries.
2.0mm “T” wrench 2.5mm “T” wrench model, but are a good idea to include in any R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers...
Page 8
DCB M41 WIDEBODY OVERVIEW Hull Water-Cooling Jacket Battery Strap Traxxas High-Current Connector Rudder Mount Motor Motor Coupler Water-Cooling Tube Steering Servo Transom Steering Linkage Flex Cable Guard Receiver Box Propeller Drive Strut Electronic Speed Control LED Light Pipe Rudder Arm...
QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.
Page 10
ESC (Electronic Speed Control) - An electronic speed control is the electronic motor control inside the model. The VXL-6s Marine Your model includes the latest Traxxas TQi transmitter with electronic speed control uses advanced circuitry to provide Traxxas Link™ Model Memory. The transmitter’s easy-to-use design precise, digital proportional throttle control.
Page 11
RADIO & BRUSHLESS POWER SYSTEM Resistance - In an electrical sense, resistance is a measure of how Voltage - Voltage is a measure of the electrical potential difference an object resists or obstructs the flow of current through it. When between two points, such as between the positive battery To prevent loss of radio range flow is constricted, energy is converted to heat and is lost.
Page 12
RADIO & BRUSHLESS POWER SYSTEM WIRING DIAGRAM Your model is equipped with the newest Traxxas TQi transmitter ESC/Motor Wiring Diagram with Model Memory. The transmitter has two Traxxas Link™ Brushless Motor channels for controlling your throttle and steering. The receiver...
Precautions for full details). Traxxas recommends you choose a genuine Refer to the troubleshooting section on page 29 for more Traxxas EZ-Peak iD charger for easy charging and maximum battery life information on the transmitter Status LED codes. and performance.
Traxxas recommended secure the batteries. To battery packs are equipped install the batteries, simply with Traxxas Battery iD. This exclusive feature allows loosen the straps, slide the Traxxas battery chargers (sold battery pack beneath them, separately) to automatically...
Page 15
This point of the steering channel. procedure will help to Note: Traxxas Stability Management (TSM) must be completely turned prevent your model off while adjusting steering trim. See page 17 for TSM adjustments. from receiving stray...
Page 16
RADIO & BRUSHLESS POWER SYSTEM USING THE RADIO SYSTEM Range-Testing the Radio System Before each running session with your model, you should range-test The TQi Radio System has been pre-adjusted at the factory. The Remember, always turn the your radio system to ensure that it operates properly. adjustment should be checked before running the model, in case of TQi transmitter on first and movement during shipping.
Page 17
RADIO & BRUSHLESS POWER SYSTEM TRAXXAS STABILITY MANAGEMENT (TSM) Setting Up the Antenna Traxxas Stability Management or TSM makes it easier to drive your The receiver antenna has been set boat faster with a greater feeling of control. While turning, TSM up and installed from the factory.
5. Move the trigger up to the full reverse position and hold it there. After about minimum recommended discharge voltage threshold for LiPo packs, the Traxxas High-Current two seconds, you will hear two beeps and red LED will blink twice. The Connector VXL-6s will limit power output to 25%.
Page 19
ADJUSTING THE ELECTRONIC SPEED CONTROL 5. Return the trigger to neutral and allow the prop to stop. Note that there is 3. While holding full throttle, connect two fully no programmed delay when changing from reverse to forward. Use caution charged battery packs to the VXL-6s Marine to avoid slamming the speed control from reverse to forward and vice versa.
DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions on • Avoid reversing for more than a few seconds at a time. Reversing causes driving and making adjustments to your model. Before you go on, here are water to rush over the stern of the boat and may cause it to sink.
DRIVING YOUR MODEL Where to Run RUN TIME Select a body of fresh water that is calm and free of debris, tree stumps, Your model is able to achieve long run times due to the greater moss, fishing line, and other things that can get tangled up in the prop. efficiency of the high voltage electrical system.
Page 22
ADJUSTING YOUR MODEL Adjusting the Trim Tabs DCB M41 Widebody features stainless steel trim tabs to help set the angle of the boat’s hull as it rides in the water. Setting the trim angle correctly will provide maximum speed and efficiency from your model. From the factory, the trim tabs are set for best all-around performance and stability at DCB M41 Widebody’s maximum speed, but you can experiment with their position to improve performance and stability in rougher water conditions.
Page 23
ADJUSTING YOUR MODEL Adjusting the Drive Strut DCB M41 Widebody has a surface-piercing prop, meaning the prop is not fully submerged when the model is at speed. Varying the Drive Strut Height depth that the prop is submerged will alter the model’s performance. Adjustment Screws The stock setting is 6mm above the lowest point of the hull and a downward angle of 2°.
Page 24
ADJUSTING YOUR MODEL RECEIVER BOX: MAINTAINING A WATERTIGHT SEAL Removing and Installing Radio Gear 3. Plug ESC and servo wires into the receiver The unique design of the receiver box allows the removal and (see page 12). installation of the receiver without losing the ability to maintain a 4.
MAINTAINING YOUR MODEL Your model requires regular maintenance for top performance. • Release the flex cable from the motor coupler as explained on The following procedures should be taken very seriously. Form the page 26, and remove the flex cable by pulling the propeller away Always wear eye protection habit of visually inspecting the mechanical integrity of the model from the drive strut.
Page 26
MAINTAINING YOUR MODEL Electronics Tray Removal DCB M41 Widebody’s unique modular design allows you to easily remove the electronics tray, allowing easy access to the hull interior and drive system. With the electronics tray removed, you can easily work on the drive system or electronics without the hull taking up your bench space.
The following section addresses some very basic questions you may have 3. Use the best batteries and charger you can afford. Low-cost, low-capacity about your model. If you can’t find a solution here, you may call Traxxas battery packs will limit the performance of your model. Likewise, a low- Customer Service at 1-888-TRAXXAS (U.S.
(set The Multi-Function knob can be set to control Throttle Sensitivity. to Traxxas Stability Management (TSM) by default, see page 17). Access Throttle Sensitivity works the same way as Steering Sensitivity, but...
Page 29
This is especially handy if you operate multiple use your TQi transmitter with a car or truck, you may find the Braking vehicles with a single transmitter via Traxxas Link™ Model Memory. Percentage function useful. When set for Braking Percentage, the Multi- Function knob will control the amount of brake travel applied by the throttle/brake servo in a nitro-powered model.
Page 30
2. Press and hold MENU. Release when the status LED blinks green. in your collection and simply turn them on and drive. With Traxxas Link 3. Press MENU three times. The status LED will blink green four Model Memory, there is no need remember which transmitter goes times repeatedly.
Page 31
Transmitter is restored to default Press Delete Model C onfirm Deletion Two Blinks Green One Blink Red *Torque Control is a feature designed only for use with the power system in the Traxxas Funny Car Race Replica (Model #6907).
Page 32
ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
Page 33
Traxxas Link Wireless Module. Traxxas Link Real-Time Telemetry The powerful Traxxas Link app (available in the Apple App Store℠ or on For more information When you equip your model Google Play™) gives you complete control over the operation and tuning...