Synchronizing Time Code On Another Camera - JVC GY-HM660U Instruction

1 Set [Main Menu] B [TC/UB] B [UB Mode] to
"Preset", and press the Set button (R).
(A P107 [ UB Mode ] )
The [UB Mode] setting screen appears.
.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the parameter is displayed as "Regen"
and cannot be selected.
(A P107 [ TC Generator ] )
2 Select [Main Menu] B [TC/UB] B "Preset"
and press the Set button (R).
The [Preset] setting screen appears.
3 Use the cross-shaped button (HI) to place
the cursor at the item to set, then use the
cross-shaped button (JK) to change the
values.
Numbers between 0 and 9 or alphabets
between A and F can be specified for the user's
bit.
.
Memo :
Press the [OIS/2] button to reset each digit to "0".
0
The cursor moves to the left.
4 Check the values and press the Set button
(R).
The user's bit is set and the screen returns
0
to [TC/UB].
To cancel the setting, press the [CANCEL]
0
button.
5 Press the [MENU/THUMB] button.
Returns to the normal screen.
70
Synchronizing Time Code
on Another Camera
This camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1 Connect the [TC] terminal of the master
device with the [TC] terminal of the slave
device.
1
Set the [TC IN/OUT] switch of the master device
to "OUT", and the [TC IN/OUT] switch of the
slave device to "IN".
Cursor
.
Master Device
Slave Device
(This Camera Recorder)
[OUT]
IN OUT
TC
[IN]
IN OUT
TC