Operation - Desa O36NRA Owner's Operation And Installation Manual

2. Place individual embers on their edge (not
flat) along the top of burner pan. This aids
in directing flames from the burner through
ember bed.
Note: Too many embers or embers placed
flat along burner pan can suppress the
flames.
3. When unit is lit, check flames for random
appearance and ember bed glowing red-
orange in color (see Burner Flame Pattern,
page 13). If this is not happening, either
add, remove or reposition loose embers.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open
when operating unit.
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted with a piezo ignitor. When
lightning the pilot, follow these instruc-
tions exactly.
b. bEFORE LIGHTING smell all around
the appliance area for gas. be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
gas control knob. Never use tools. If
the knob will not push in or turn by
hand, do not try to repair it, call a quali-
fied technician. Force or attempted
repair may result in a fire.
124868-01A
INSTALLATION
Continued
IMPORTANT: Turn unit off and let cool
before repositioning loose embers.

OPERATION

D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been under
water.
1. STOP! Read the safety information,
above.
2. Make sure switch is in the OFF position.
3. Be sure gas line shut-off valve is OPEN.
4. Press in and turn control knob clock-
wise
Figure 15).
Note: Knob cannot be turned from PILOT
to OFF unless knob is pushed in slightly.
DO NOT FORCE.
5. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow "B" in
the safety information in column 1. If you
don't smell gas, go on the next step.
6. Press in and turn control knob counter-
clockwise
Press in control knob for five (5) seconds
(see Figure 15).
Control
Knob
www.desatech.com
Figure 14 - Placement of Embers
LIGHTING
INSTRUCTIONS
to the OFF position (see
to the PILOT position.
Piezo
Ignitor
Flame Adjustment Knob
Figure 15 - Setting Control Knobs
11