HP StorageWorks DAT 40i Getting Started Manual page 44

Hide thumbs Also See for StorageWorks DAT 40i:
Table of Contents

Advertisement

The server boots but does not recognize the tape drive
Possible reason
The power or SCSI cable is not connected
properly.
The SCSI bus is not terminated correctly.
The tape drive's SCSI ID address is not
unique.
The application does not recognize the tape drive
Possible reason
The application does not support the tape
drive.
Some applications require drivers to be
loaded.
The drive does not work
Possible reason
If the drive does not power up, the power
cable may not be connected to the drive
properly.
If the self-test fails, there may be a hardware
or firmware failure.
There is a hard error on the drive.
40
Recommended action
Check that the cables to the tape drive are firmly
connected. Ensure that the SCSI cable does not have
any bent pins. Replace, if necessary.
Check that the SCSI bus is actively terminated. (Refer
also to the documentation for your SCSI controller
and any other SCSI devices you may have.)
Make sure that each device connected to the SCSI
controller has a unique SCSI ID. Remember that 7 is
normally reserved for the host bus adapter. (Users of
most operating systems can run HP Library & Tape
Tools to check the SCSI IDs of each device attached
to the SCSI bus, see page 35.)
Recommended action
Use HP Library & Tape Tools to check that the drive is
installed properly. Refer to our World Wide Web site
(
www.hp.com/go/connect
backup applications that support the
HP StorageWorks DAT tape drive. Load any service
packs as necessary.
Check that the correct SCSI and tape drive drivers
are installed. Consult the backup application's
installation notes for details.
Recommended action
Check the power cable connection and try another
cable if necessary. If the drive still does not power
up, call for service.
If there is a cartridge in the drive, remove it. Power
down the drive and power it up again. If the self-test
still fails, call for service.
The Media Caution (Clean) LED shows steady amber.
Try powering the system off and then on again. If the
error condition signal still shows, call for service.
) for details of

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks dat 72i

Table of Contents