Table of Contents
Advertisement
6.
Touch "Start".
This starts the Interval Snapshot operation.
• Starting an Interval Snapshot operation causes the camera and controller to
enter a sleep state and standby for recording of the images. This will be
indicated by the camera's operation lamp flashing green. Note that the camera
will not enter the sleep state if "5 sec" is selected for the "Interval" setting.
• To recover from the sleep state, press any
controller button. Next, touching "
monitor screen will display the number of recorded
images. Though the maximum displayed image
count is 9999 images, an Interval Snapshot
operation can shoot more than 9999 images as
long as the camera is supplied with power using
the supplied USB-AC adaptor, etc.
NOTE
• Interval Snapshot images are shot using Auto Focus.
• Camera image stabilization is applied during movie recording by an Interval
Snapshot operation. Note, however, that image stabilization does not prevent
image blur due to subject movement.
• The current shooting setup, including zoom, cannot be changed while an Interval
Snapshot operation is in progress.
• If the camera battery goes dead during an Interval Snapshot operation, the
operation will terminate. The controller battery going dead does not affect an
ongoing Interval Snapshot operation. To stop the Interval Snapshot operation in
this case, hold down [p] (Power) on the camera.
• If you are performing manual camera operations or if the camera is out of the sleep
state when the Interval Snapshot operation reaches a shooting interval, Interval
Snapshot recording for that interval will be skipped.
• Pressing the controller's [p] (Power) button while the camera is out of the sleep
state will return to the sleep state and restart the Interval Snapshot operation.
" on the
37
Recording Images
Advertisement
Table of Contents
