Renault CAPTUR Driver's Handbook Manual page 107

TYRE PRESSURE LOSS WARNING
2
SYSTEM B (cntd.)
Resetting procedure
With the ignition on:
– repeatedly press one of the but-
tons 3 or 4 to select the "LEARNING
THE TYRE PRESSURE" function
on the display 2;
– press and hold (around 3 seconds)
button 3 or 4 to start initialisation. The
display of the message "PRESSURE
REF ONGOING" for around 5 sec-
onds indicates that the reset request
for the tyre pressure reference value
has been taken into account.
(6/7)
Reinitialisation is carried out after a few
minutes' driving.
Note:
3
The standard tyre pressure cannot be
less than that recommended and indi-
cated on the door frame.
Display
4
The display 2 on the instrument panel
informs you of any tyre pressure faults
(flat tyre, punctured tyre, etc.).
"ADJUST TYRE PRESSURE"

Warning light
with the message "ADJUST TYRE
PRESSURE".
These indicate that at least one tyre is
flat.
Check and, if necessary, readjust the
pressures of the four wheels when cold.
The warning light
few minutes' driving.
The sudden loss of pressure in a
tyre (burst tyre, etc.) cannot be de-
tected by the system.
comes on, along

goes off after a
"PUNCTURE"

The warning light
steady, accompanied by the message
"PUNCTURE" and a beep.
This message is accompanied by the
®
warning light .
They indicate that at least one wheel
is punctured or severely underinfla-
ted. Replace it or contact an authorised
dealer if it is punctured. Top up the tyre
pressure if the wheel is deflated.
®
Warning light
quires you to stop immedi-
ately, for your own safety,
as soon as traffic conditions
allow.
comes on
re-
2.25