Citizen CT-S281 User Manual page 32

Manual Setting of Memory Switch (Memory SW)
The memory switch can be selected, changed, or written by the combination of
three actions: pressing the FEED button, pressing and holding the FEED button,
and opening or closing the printer cover.
1. Entering memory switch setting mode.
Set paper to the printer and keep the printer cover open. With the FEED
button pressed and held, turn the printer power on, and then press the
FEED button twice. Close the cover. If the current settings of the memory
switch etc. are printed, the printer is now in the memory switch setting
mode.
Memory SW (1) 00000000
2. Selecting memory switch
When the FEED button is pressed short (within 2 seconds), printing occurs
in the order of "Memory SW1" → "Memory SW2" → "Memory SW3" →
"Write/Factory Setting" → "Memory SW1" → ...... repeatedly. When the
memory switch you want to change is reached, press and hold the FEED
button (for more than 2 seconds). The reserved memory switch setting
will be skipped and not printed.
3. Selecting each switch item
There are eight setting items for each switch. Press and hold the FEED
button for long, the printer goes to the next item and prints the current
setting of the item. Repeat pressing and holding till the item you want to
change setting is reached.
Power ON Info (Valid)
4. Changing the setting
When the item you want to change is reached, press the FEED button short.
The changed set value is printed. (To return to the previous setting press
the FEED button short). When you press the FEED button long, the set
value is accepted and then the printer goes to the next setting item.
5. Returning to the memory switch select mode
When the setting of the desired content is completed, open the printer
cover and then close the printer cover. This allows the printer to print the
setting of the changed memory switch.
— 29 —
0: OFF state
1: ON state
Items with ERROR LED lit are
those values elected currently