Snap Disc And Side Panel Installation; Blower Installation - Quadra-Fire 31-I ACC Installation Manual

31-I ACC
J. Snap Disc and Side Panel Installation
1. Place snap disc box in location shown in Figure 22.1.
2. Secure the wires through the wire clip to keep in place.
3. Route the blower wires underneath appliance through the
wire channel to the other side of the appliance.
Blower Wires
Figure 22.1
K. Blower Installation
1. Remove top and bottom screw from inner panel.
2. Slide blower mount with blower attached behind the face
and secure with 5 screws provided, 3 on the right side
and 2 on the left. Figure 22.2.
3. Connect the blower to the wire harness and secure
through the wire clip.
4. Install left side panel.
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
22
4. Tilt the side panel forward under the top and push the
5. Attach the side panel to the appliance with 2 screws, 1 at
6. Repeat for other side once the blower has been installed.
Face Pegs
Wire Channel
Figure 22.2
7044-225D
panel onto the pegs on the face.
the top and 1 at the bottom on the right side of panel.
Wire Clip
Snap Disc Box
Left Side
Panel Screws
Inner Panel
Side Panel
Screws
Blower
Mounting
Screws
Wire Clip
August 3, 2015