Advertisement
6. Output Binding Posts:
The RED binding post is connected to the
positive amplifier output. Connect to this post
the (+) terminal on the loudspeaker..
The BLUE binding post is connected to the
negative (-) output. Connect to this post the (-)
terminal on the loudspeaker.
Never connect either binding post to an
electrical ground!
The output binding posts provide three different
interconnect options: banana plugs, spade lugs,
and bare wire. Combinations may be used when
bi-wiring. Cables should be kept as short as
practical and should never be terminated with
connectors that may become confused for AC
power connectors. Cables should be dressed
away from input and power cables.
7. Master Fuse Compartment:
The 2.5B
is protected by an AC Mains fuse
3
specifically rated for the AC power in your
region. The fuse must be installed and in tact
for the amplifier to power on and operate. Only
replace the fuse with one of identical value.
Do not attempt removal or replacement of the
fuse when the amplifier is plugged into the
wall!
8. A/C Power Input:
An IEC-320 C14 power inlet provides for
connection of an IEC-320 C13 equipped power
cord. Before connecting the power cord to the
amplifier, check that the voltage rating on the
data plate or ratings label conforms with your
locality.
2.5B
Amplifier
3
9. Remote Power Up:
With the front panel switch in the OFF position,
the Power On state can governed by voltage
applied to IN terminals of the Remote Power Up
connector. See "External Control Voltage" on
page 5 for instructions regarding connection
and usage.
10. Fuse Data Label:
Fuse replacement values are specific to your
unit's operating voltage. The installed fuse will
match these values.
11. Data Plate:
Unit specific information is printed here
including model number, operating voltage,
frequency, and serial number.
2.5B3-17-SIL-120
~120V 60Hz 745W
Serial No:
Date: 1530
2.5B3-00000
REV: 1234
9
Advertisement
