Jacking Instructions; Jacking Instructions - Toro Pro Sweep 07066 Service Manual

Jacking Instructions

CAUTION
When changing tires or performing other ser-
vice, use correct hoists and jacks to support
sweeper. Make sure machine is parked on a sol-
id level surface such as a concrete floor. Always
chock or block wheels. Use appropriate jack
stands to support the raised machine. If the ma-
chine is not properly supported by appropriate
jack stands, the machine may move or fall,
which may result in personal injury.
1. Position sweeper on a level surface with dump hop-
per empty and lowered. Have sweeper attached to tow-
ing vehicle, apply vehicle parking brake, stop engine
and remove key from the ignition switch. Chock sweep-
er wheels to prevent it from moving.
2. Position jack securely under the main sweeper
frame (Fig. 1). Do not use the axle as a jacking point.
3. Carefully jack machine off the ground.
4. Position appropriate jack stands under the main
frame to support the sweeper.
Safety
1. Wheel
Page 1 - - 4
1
2
Figure 1
2. Frame jacking point
Pro Sweep