Toro Pro Sweep 07066 Service Manual page 79

Wheel Removal (Fig. 2)
1. Position sweeper on a level surface with dump hop-
per empty and lowered. Have sweeper attached to tow-
ing vehicle, apply vehicle parking brake, stop engine
and remove key from the ignition switch. Chock sweep-
er wheels to prevent sweeper from moving.
2. Jack or hoist sweeper from ground and support ma-
chine with appropriate jack stands (see Operator's
Manual and Jacking Instructions in Chapter 1 -- Safety).
3. Loosen and remove five (5) lug nuts from wheel to be
removed.
4. Pull wheel from sweeper.
Pro Sweep
Wheel Installation (Fig. 2)
1. Position wheel to wheel hub.
2. Secure wheel to sweeper with five (5) lug nuts.
3. Carefully lower machine to ground.
Failure to maintain proper lug nut torque could
result in failure or loss of wheel and may result in
personal injury.
4. Torque lug nuts in a criss--cross pattern from 70 to 90
ft- -lb (95 to 122 N- -m).
Page 5 - - 5
WARNING
Chassis