Brush Motor - Toro Pro Sweep 07066 Service Manual

Brush Motor

RIGHT
FRONT
1. Brush housing
2. Coupling cover (2 used)
3. Lock washer (8 used)
4. Cap screw (8 used)
5. Lock nut (2 used)
6. Flat washer (2 used)
7. Carriage bolt (6 used)
Removal (Fig. 13)
1. Position sweeper on a level surface with dump hop-
per empty and fully lowered. Chock sweeper wheels to
prevent sweeper from moving. If sweeper is attached to
tow vehicle, apply tow vehicle parking brake, stop en-
gine and remove key from the ignition switch.
Hydraulic System
19
8. Coupling assembly
9. Hydraulic hose (2 used)
10. O- -ring (2 used)
11. Hydraulic fitting (2 used)
12. O- -ring (2 used)
13. Cap screw (2 used)
14. Hydraulic brush motor
Page 3 - - 24
94 to 116 ft- -lb
(128 to 157 N- -m)
1
7
17
20
17
18
Figure 13
Before disconnecting any hydraulic compo-
nents, operate all sweeper hydraulic controls to
relieve system pressure and avoid injury from
pressurized hydraulic oil. See Relieving Hydrau-
lic System Pressure in the General Information
section of this chapter.
4
3
2
5
6
8
16
15
15. Flat washer (6 used)
16. Lock nut (6 used)
17. Bearing flange (4 used)
18. Square key
19. Brush assembly
20. Bearing assembly
CAUTION
9
10
11
12
13
14
Pro Sweep