Nissin Air R Instruction Manual page 9

For Canon camera model EOS 1DX, 7DM2 and 5Ds Only
For using with Canon camera model EOS 1DX, 7DM2 and 5Ds.
Before Binding setting, please follow the technical setting below on
Commander Air 1.
Step 1: Commander Air 1 is OFF
Step 2: Hold "Mode" and on/ off switch for two seconds until Pilot button Blinking
(orange/ white)
Step 3: Hold on/off switch for 5 seconds to turn off the Commander unit
Step 4: Binding setting
(please follow the binding instruction on page 9)
Air 1
Commander
* Repeat step 1 to 3 for Canceling the technical setting
For Nikon Only
Since Nikon type flash units has some variation between models, the
therefore Receiver Air R needs to recognize which Nikon type flash unit is
plugged on it. By doing this recognition 1)Just install your Nikon type flash
unit on your Receiver Air R. 2) Power them on until ready. 3) Make sure
that the group selected on the Air R is not turned off at thr commander Air
1. Press the pilot button on the Commander Air 1 to cause your grouped a
flash unit to emit flash. 4) The recognition is complete.
***The recognition process is important otherwise the TTL exposure may not be
corrected***
For Sony Only
For using with Sony cameras.
Before using the Commander Air 1, please install Air 1 on
camera and change the Flash mode to "WL" in camera menu.
For Sony Only - HSS High-Speed Synchronization
Air 1 supports shutter speeds up to 1/8,000 second.
High-speed Synchronization: In M/ TTL mode.
High-speed Synchronization is controlled by Air 1.
To enable/ disable on Air 1:
ON: Press and hold Pilot button for 3 seconds.
Pilot button starts blinking twice.
OFF: Press and hold Pilot button for 3 seconds to cancel the setting .
High-speed mode uses higher flash energy. To protect the flash from overheat,
the recycling time will be extended to a minimum of 7 seconds.
A
B
C
Z
Mode
S
unlock
Hold 2 sec
Blink
Completed & turn off
8