Servicing The Diamondshield; Diamondshield Tm Removal / Installation - Mitsubishi Electric WT-46807 Service Manual

MODELS: WT-46807 / WS-55807 / WS-55857 / WS-55907 /WS-65807 / WS-65857 / WS-65907 / WS-73907
1. DiamondShield™ Removal Procedure
The location of the DiamondShield
the appropriate disassembly procedure given below.
Note: Wear gloves when handling the DiamondShield™ to prevent finger prints.
Top & Bottom Molding Clips
1. Gently insert a small screwdriver between the
DiamondShield™ and one end of the clip to
pry the clip loose.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the
gap at the top/center point of the Shield and
pull the Shield slightly away from the unit.
Place your hands at the points shown and
gently bow the Shield toward you and remove
from the unit. Then re-install the two clips.
2. DiamondShield™ Installation Procedure
*(See the Parts List for DiamondShield™ part numbers)
To install the DiamondShield

SERVICING THE DIAMONDSHIELD™

TM molding clips varies between models, top and bottom, or sides. Use
TM , reverse the above Removal Procedure.
Page 17
Side Molding Clips
1. Gently insert a small screwdriver between the
DiamondShield™ and one end of the clip to
pry the clip loose.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the
gap at the side/center point of the Shield and
pull the Shield slightly away from the unit.
Place your hands at the points shown and
gently bow the Shield toward you and remove
from the unit. Then re-install the two clips.