Table of Contents
Advertisement
MODELS: WS-48513 / WS-48613 / WS-55513 / WS-55613 / WS-55813 / WS-65513 / WS-65613 / WS-65713 /
WS-65813 / WS-73513 / WS-73713
1. DiamondShield™ Removal Procedure
The appropriate disassembly procedure given below.
Note: Wear gloves when handling the DiamondShield™ to prevent finger prints.
1. Gently insert a small plastic card (such as a
credit card or a plastic putty knfe) between the
DiamondShield™ and one end of the clip to pry
the clip loose.
3. Carefully insert the small plastic card (or plastic
putty knife) into the gap at the side/center point
of the Shield and pull the Shield slightly away
from the unit. Place your hands at the points
shown and gently bow the Shield toward you
and remove from the unit.
2. DiamondShield™ Installation Procedure
*(See the Parts List for DiamondShield™ part numbers)
To install the DiamondShieldTM, reverse the above Removal Procedure.
SERVICING THE DIAMONDSHIELD™
Page 24
2. Remove both clips by pulling them toward you.
4. Reinstall the two clips
Hide quick links:
Advertisement
Table of Contents
