Harman Kardon BDS 275 Owner's Manual page 19

BDS
4. Remain silent while the test noise plays through the speakers. As the test noise
circulates among the speakers the screen will show which speaker is being tested.
Audio Settings
EzSet/EQ(Automatic Setup)
Testing...
Please keep room
silent during EzSet/EQ.
EzSet/EQ automatic setup can calibrate the BDS system and configure
loudspeaker parameters automatically to get the best sound performance.
5. When the testing process is completed, the "Testing..." message on the screen will
change to "Test complete."
6. Press the Back button to exit the EzSet/EQ test procedure.
NOTE: If the test fails, the "Testing..." message on the screen will change to "Test failed,
please make sure all speakers are connected correctly and the room is quiet then try
again." Press the Back button, make sure all speakers are correctly connected and
perform the test again from Step 4. Make sure that the room remains quiet during the
test.
Manual Configuration: After you select your speaker system's configuration, the speaker
setup screen will appear:
Audio Settings
Tone Controls
Audio Output
LS
Speaker Settings
Left (0.0 dB, 0.0m/0ft)
Right (0.0 dB, 0.0m/0ft)
Setting the speaker distances:
1. The front left and front right speakers will be highlighted. Press the OK button. The
Level and Distance selection screen will appear.
Audio Settings
Tone Controls
Audio Output
LS
Speaker Settings
Left (0.0 dB, 0.0m/0ft)
Right (0.0 dB, 0.0m/0ft)
S S
S
C
L R
RS
SUB
C
L R
RS
Level
SUB
Distance
2. Press the Cursor Down button to highlight Distance, and press the OK button. The
Distance adjustment bars will appear.
Audio Settings
Tone Controls
Audio Output
LS
Speaker Settings
Left (0.0 dB, 0.0m/0ft)
Right (0.0 dB, 0.0m/0ft)
3. Measure the distance from the listening position to each of your system's speakers,
including the subwoofer. Write down the distances.
4. Use the Cursor Left and Right buttons to adjust the "L" bar until it shows the distance
you measured to the front left speaker (the arrowheads indicate which speaker is
being adjusted).
5. Press the Cursor Down button to highlight the "R" bar. Use the Cursor Left and Right
buttons to adjust the bar until it shows the distance you measured to the front right
speaker.
6. Press the Back button twice to return to the speaker setup screen (the front left and
front right speakers will still be highlighted).
7. Press the Cursor Down button. The subwoofer will be highlighted. Press the OK
button. The Level and Distance screen will appear.
8. Repeat Steps 2 – 7 for the center speaker, surround speakers and subwoofer.
9. When you have entered the distances to all of your system's speakers, press the
Back button repeatedly to return to the Home Menu screen.
NOTE: Leave all the speaker levels set at "0" for now. You will be able to adjust the
individual speaker levels once your system is set up and you're playing music or films.
See Adjusting Individual Speaker Volumes, on page 20.
Information Menu
MAC Address:
Softare Verison:
MCUVer : 41.0
MCU2Ver : 15
The Information menu will display the receiver's software/firmware version number and
the receiver's factory-assigned network MAC address. This screen is for information only
and has no user adjustments.
Setting Up the Receiver
C
L
L R
RS
SUB
Left
0
Right 0
000 -1C -50 00 -D9 -50
BDS_275 EU V2.3.0
DspVer : 17
MFIVer : 6
19