Panasonic S-45PU1E5 Technical Data & Service Manual page 330

1
U1, Y1, T1, F1, N1 Types
Caution
This unit may be used in a single-type refrigerant system where 1 outdoor unit is connected to 1 indoor
unit, and also in a system where 1 outdoor unit is connected to multiple indoor units (maximum 2).
* If multiple indoor units are used, also refer to section "System Control".
The indoor and outdoor unit control PCB utilizes a semiconductor memory element (EEPROM).
The settings required for operation were made at the time of shipment.
Only the correct combinations of indoor and outdoor units can be used.
This test run section describes primarily the procedure when using the wired remote controller.
Test Run Procedure
Turn ON the indoor
and outdoor power.
(Automatic Address Setting)
(*1)
Recheck the items to check before the test run.
Check the combination (wiring) of indoor and outdoor units.
Is system "single-type"?
YES
(1 indoor unit is connected
to 1 outdoor unit and remote
Is group control with multiple outdoor units used?
Turn ON the indoor and outdoor power.
Indicate (mark) the combination number.
Set the remote controller to "test run".
Return the remote controller to normal control.
controller)
NO
NO
Can
NO
operation be
started?
YES
1-320
See section "Items to Check
Before the Test Run"
See section "System Control"
See section "Setting the outdoor
unit System Address"
Set the outdoor
YES
unit system
address.
See section "Automatic address
setting using the remote controller"
Use the remote
Automatic
controller to
address
perform automatic
setting
address setting.
See section "Indicating
(marking) the indoor
and outdoor unit
combination number"
See section "Test Run Using
the Remote Controller"
Refer to "Table of Self-
Diagnostic Functions"
to check the system.
In addition, refer to
8-8-1 to 5 and correct
any items that need to
be corrected.
Note: Check the indoor-side drainage.
(*1) Required for simultaneous-operation
multi systems and for group control.