Table of Contents
Advertisement
Indicator
Illuminated (red)
display
It is nearly time to
replace the lamp
Problem
unit.
• Does "REPLACE
LAMP" appear on
Possible
the screen after the
cause
projector is turned
on?
• This occurs when
the operation time
for the lamp unit is
nearing 1 800
hours. (when
LAMP POWER has
been set to
Remedy
"HIGH") Ask your
dealer or an
Authorised Service
Centre to replace
the lamp unit.
NOTE:
• Be sure to turn off the MAIN POWER switch by following the procedure
given in "Turning off the power" on page
procedures in the "Remedy" column.
• If the main power turns off after the TEMP indicator starts flashing, it
means that an abnormality has occurred. Please contact an Authorised
Service Centre so that the necessary repairs can be made.
50-E
NGLISH
LAMP indicator
Flashing (red)
An abnormality has been detected in the lamp
circuit.
• The power may
have been turned
on straight away
after it was turned
off.
• Wait for a while
until the lamp unit
cools down before
turning the power
back on again.
28
before carrying out any of the
• There may be an
abnormality in the
lamp circuit.
• Turn off the MAIN
POWER switch by
following the
procedure given on
page 28, and then
contact an
Authorised Service
Centre.
Advertisement
Table of Contents
