Example of setting for use of the
projector LAN card
Usage of projector LAN card is classified into the following two types.
Note:
• The optional projector LAN card (ET-CDLAN1) cannot be used in a personal
computer.
To directly connect a personal computer to the
projector
Mount an optional projector LAN card
(ET-CDLAN1) on the projector, connect
the PC to this card with a cross cable, and
then make setting for communication.
For details of setting the projector, refer
to "Setting the projector" on page 94.
For details of setting the PC, refer to
"Settings of personal computer" on page
102.
Typical setting
Parameters
IP address
Subnet mask
When connecting via a relaying device
When a hub or other relaying device is
placed between the projector and PC,
make setting for communication.
For details of setting the projector, refer
to "Setting the projector" on page 94.
For details of setting the PC, refer to
"Settings of personal computer" on page
102.
Typical setting
Parameters
IP address
Subnet mask
Note:
• Read and follow the instruction manual for that relaying device.
Setting of the projector
LAN 1 - 5:
192.168.10.10-14
(factory default)
255.255.255.0
(factory default)
Setting of the projector
Please consult your network administrator.
Please consult your network administrator.
Setting of the PC
Assign an address such as
192.168.10.15 or 192.168.10.20.
The same IP address as the
projector cannot be used.
255.255.255.0
Straight cable
Setting of the PC
R
R
E
-93
NGLISH