Disassembly Procedure - Yamaha an200 Service Manual

AN200

DISASSEMBLY PROCEDURE

Bottom Assembly
(Fig. 1)
[180]: Bind Head Tapping Screw-B 3.0X6 MFZN2Y (EP600130)
[185]: Bind Head Tapping Screw-B 3.0X6 MFZN2Y (EP600130)
1. Bottom Assembly (time required: about 1 min)
1-1 Remove the five (5) screws marked [180] and the
two (2) screws marked [185]. The bottom assembly
can then be removed. (Fig. 1)
* If you turn the mixer upside down for disassem-
bling and assembling, put 2 wooden bolsters
underneath the unit at its both side ends to protect
the PN circuit board from being damaged.
(Fig. 1-1)
2. PLG150-AN Circuit Board
(time required: about 1 min)
2-1 Remove the bottom assembly. (See Procedure 1.)
2-1 Remove the tree (3) screws marked [160]. The
PLG150-AN circuit board can then be removed. (Fig. 2)
* Attachment consideration of the PLG150-AN circuit board.
When installing the PLG150-AN circuit board, do
with connector assembly as shown in the fig 2-1.
Fit the PLG150-AN circuit board caring not to let
the connector assembly in it.
8
PLG150-AN
[130]
[120]: Bind Head Tapping Screw-P 2.6X8 MFZN2Y (EP620100)
[130]: Angle, L (V655450)
[140]: Angle, R (V655460)
[160]: Bind Head Tapping Screw-B 3.0X86 MFZN2Y (EP620130)
[180]
Wooden bolster
[185]
[160]
*1
*1
DM
[120]
AN200
Bottom side
(Fig. 1-1)
(Fig. 2)
[140]