Using Your Machine; Filling The Tank; Using The Steam Mop - Vax S84-P1-B Let's Get Started

Using your machine

IMPORTANT: Don't over fill the tank. Don't use the steamer without water in the tank. Always top up with water in good time.

Filling the tank

Grip the handle press the tank Pull the tab on the tank cap to open.
release buttons and pull the Fill the tank with water. Replace the
tank to remove. cap and push firmly to close.
Line up the tank with the machine, Important: If the tank is not fitted
push the tank until it clicks into place. correctly there will be a reduction
in the amount of steam produced.
Before replacing the tank make
sure the hard water filter which is
located behind the tank is in place.
WARNING: Always unplug the steamer when fitting the microfibre cleaning pads.
IMPORTANT: Never use the steamer without a cleaning pad attached to the floorhead. Never leave the steamer on one spot
for an extended period of time or with a damp or wet microfibre pad attached as this may damage the floor surface.

Using the steam mop

Place the microfibre pad on the Plug into mains. The blue light will
floor with the tab side facing up. illuminate to indicate power on.
Place the floorhead onto microfibre The green light will illuminate to
pad making sure the microfibre indicate the steamer is ready to use.
pad covers the entire floorhead.
To produce steam squeeze the Move the steamer slowly backwards
trigger in short bursts. Don't hold and forwards across the floor
the trigger continuously to prevent paying particular attention to high
over wetting floors. traffic areas. Squeeze/release
trigger as required.
Using your machine
Place your foot onto the
floorhead and pull the
handle backwards to recline.
After cleaning, return steamer
to upright position, lock into place
and unplug the steamer.
Allow the steamer to cool down.
Hold the corner of the microfibre
pad down with your foot and lift
steamer to peel away.
If the area you
are cleaning is
becoming too wet,
squeeze the trigger
in short bursts.