Citizen CT-S300 User Manual page 9

Please observe the following precautions for power source and power cord:
G Do not plug or unplug the power cord with a wet hand.
G Use the printer only at the specified supply voltage and frequency.
G Use only the specified AC adapter with the printer.
G Check to make sure that the supply outlet from which the printer is powered has
a sufficient capacity.
G Do not supply the printer from a power strip or current tap shared with other
appliances.
G Do not plug the power cord into a supply outlet with dust or debris left on its
plug.
G Do not use a deformed or damaged power cord.
G Do not move the printer while the printer power is on.
• Neglecting to handle properly may result in printer failure, emission of smoke,
fire, or electric shock.
• An overload may cause the power cord to overheat or fire or the circuit breaker
to trip.
G Do not allow anything to rest on the power cord. Do not place the printer where
the power cord will be trampled on.
G Do not use or carry the printer with its power cord bent, twisted, or pulled.
G Do not attempt to modify the power cord unnecessarily.
G Do not lay the power cord in the neighbor of a heating device.
• Neglecting these cautions may cause wires or insulation to break, which could
result in leakage, electric shock, or printer failure. If a power cord sustains damage
contact your CBM dealer.
G Do not leave things around the supply outlet.
G Supply power to the printer form a convenient wall outlet, readily accessible in
an emergency.
• The printer may not be immediately shut down in an emergency.
G Insert the power plug fully into the outlet.
G If the printer is not to be used for a long time, leave it disconnected from its
supply outlet.
G Hold the plug and connector when plugging or unplugging the power cord or
signal cable after turning off the printer and the appliance connected to it.
WARNING
— 5 —