Preparing To Use The 5U Library Control Module - Dell PowerVault ML6000 Maintenance Manual

11 If tape blockers are required, make sure they are installed in the bottom two rows of the library. The tape
blockers block slots in the bottom two rows of the library. You can insert the tape blockers through the
open access door.
CAUTION
1 access door

Preparing to Use the 5U Library Control Module

1 Close the library's I/E station and access doors.
2 Add the tape drives to the modules. For details, see
page 127.
3 Add the power supplies. For details, see
106.
4 Install the LCB from the removed 5U Library Control Module in the new 5U Library Control Module. For
details, see Removing and Replacing the Library Control Blade and LCB Compact Flash Card
102.
5 Connect all power cords, network data cables, and module-to-module cables. Make sure the module
terminators are installed in their previous positions at the top and bottom of the stack of modules. For
cabling instructions, see
6 Power on the library.
7 Re-create and/or modify partitions, cleaning slots, and I/E station slots as desired.
PowerVault ML6000 Maintenance Guide
Libraries that have a Model 2 robot installed no longer use tape blockers. If
your library contains a Model 2 robot, do NOT install tape blockers. For
more information, see Removing and Replacing the Robot Assembly
page 164 and How to Determine Which Robot Your Library Contains
page 165.
1
2
Adding, Removing, and Replacing Power Supplies
Cabling the Library on page 22.
2 tape blockers (installed)
Adding, Removing, and Replacing Tape Drives
on
on
on
on page
on page
91