Special Remarks - Panasonic S-12MT2U6 Operating Instructions Manual

Heating Performance
Defrosting
Heating Standby
When Heating Operation
Started (Only 3WAY VRF)
Oil Recovery
Remote Control Sensor
Should the power failure
occurs while the
unit is running

SPECIAL REMARKS

• Since this air conditioner utilizes outside air for heating, its heating performance
deteriorates as outside temperature decreases. (Due to heat pump system)
• It will take some time until the room becomes warmer after heating operation started. (Due
to hot air circulation system in order to heat a whole room)
• This appliance may start defrosting operation to melt frost form in the outdoor unit during
long hour heating operation mode.
The indoor unit fan will stop for about 5 to 10 minutes at this time.
The remote controller shows "
the indoor unit fan may be controlled.
• When operation started (Indoor unit fan stops for maximum 6 minutes.)
• When Thermostat activated
• When defrosting (Indoor unit fan stops.)
When changed to heating mode from stopped or cooling operation mode, the unit does not
work for about 3 minutes for the sake of self-protection.
It may take about 5 to 10 minutes until the hot air is delivered after starting the heating
operation.
The indoor unit fan may stop or run at a slow speed in order to recover the oil in the system
every 1 to 3 hours during cooling or heating operation.
The unit will automatically resume the original operation after about 5 to 10 minutes.
The temperature sensor in the indoor unit normally senses the room temperature and can also
sense the ambient temperature of the remote controller.
For the details, consult the shop you purchased.
When the unit automatically resumes operation after temporary power failure, it uses the same
settings before the power was cut off.
" (Heating standby) on the display in the following mode and
7