Cowling; Fuselage; Decal - THUNDER TIGER Sept. Fury Assembly Manual

COWLING

87. Install the engine cowling; first glue the plywood
doublers inside the fuselage at where hole is . Trial fit
the cowling in place and temporarily secure it with mask
tape. Drill 1/16"(1.5mm) at the place where doublers
are.
88. Drill needle valve extension wire exit hole. When
satisfied, secure the cowling in place with 2.3x12mm
Washer Wood Screws.Suggest to install Precision Fueler
(TTR1115) for easy fueling.
89. Install the propeller and furnished spinner. What we
used here is Master Airscrew 13x8.
90. Suggest to file the cowl located near the vent of
carburetor as shown, the engine will get enough air and
run smoother if you install a 2 stroke engine.
91. Apply instrument panel in the cockpit. Next trim the
canopy and trial fit the canopy on the cockpit. Glue the
plywood doublers and drill four 1/16" ( 1.5mm ) holes.
Secure the canopy with four 2x5mm washer wood screws.
Pilot shown is not included.
22
92.Refer to the box label then apply all decals. Suggest
to join the fire decals together before applying on

fuselage.

95.You may need to remove the cowling and apply silver
decal as shown.

DECAL

93.The photos shown is the decal at retract gear door.
94.Trial fit the upper Cockpit on fuselage, drill eight 1/16"
(1.5mm) holes and glue small plywood doublers inside
the fuselage at the holes area. Drill the doublers again
and secure the cockpit in place with 2x8mm washer wood
screws.
Your Sept. Fury is now ready to fly, carefully set up the
control throws and balance your plane well before each
and every flight; never take chances or rush fly your
Sept. Fury.
23