Connecting An Antenna Or Cable Tv (No Box) - Insignia NS-43DR710NA17 Roku TV User Manual

Connecting an antenna or cable TV (no box)

On your TV
Coaxial cable
connector
ANT / CABLE
jack
1 Make sure that your TV's power cord is unplugged and all connected devices are turned off.
2 Connect a coaxial cable (not provided) to the ANT / CABLE jack on the back of your TV and to the antenna or cable
TV wall jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 On the Home menu, press
5 Set up the TV tuner to watch broadcast TV. See
Antenna TV tile, your TV tunes to the first channel in the channel list.
Notes
• Use a coaxial cable to eliminate interference and noise from radio waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a
highly directional outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the problem may be caused by
a poor or weak signal from the broadcaster or cable TV provider.
• If you connect to cable TV without a set-top box and experience poor picture quality, you may
need to install a set-top box to improve signal reception and picture quality. Contact your cable TV
provider about upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it
would be if the content was originally recorded in HD.
20
Back of TV
or then highlight the tile for Antenna TV, then press OK.
Setting up Antenna TV
www.insigniaproducts.com
43"/50"/55" 4K / 2160p, 60Hz, LED Roku TV
Antenna or cable TV
(no box)
Coaxial cable
on page 45. When you finish setting up the