Troubleshooting - ALDI 51488 User Manual

45cc Petrol Chainsaw

Troubleshooting

Problem
Engine will not start
Engine starts but will
not accelerate
properly.
Engine does not
reach
full speed and/
or emits excessive
smoke
Guide bar (18) and
chain (19) running
hot and smoking.
AFTER SALES SUPPORT
1800 909 909
(toll free)
Possible Cause
On /off switch (4) is in off position.
No spark in the spark plug (16).
Failed ignition Coil.
Flooded engine
Carburettor requires adjustment.
Fuel contaminated or not fresh.
Incorrect fuel mix
Check oil / fuel mixture
Air filter (13) dirty.
Carburettor requires adjustment
Chain brake (12) engaged.
Chain tension too tight.
Check guide bar (18) and chain
(19) assembly.
Guide bar (18) and chain (19)
are damaged.
Oil not lubricating guide bar (18).
Solution
Lift on/off switch (4) to the "ON" position.
Clean the spark plug (16).
Replace the old spark plug (16) with a
new one.
Take the unit to Service Agent.
With the on/off switch (4) off, remove
spark plug (16) from the engine. Move choke
control (9) to the RUN position (pushed in
completely), and pull the recoil starter (10)
15 to 20 times. This will clear excess fuel from
engine. Clean and
reinstall spark plug (16). Set on/off switch (4)
to the On (I) position. Pull the recoil starter
(10) three times with choke control (9) at
RUN. If engine does not start, move choke
control (9) to CHOKE and repeat normal
starting procedure.
If engine still fails to start, repeat procedure
with a new spark plug (16).
Refer to page 21 for adjustment, however,
it is recommended this adjustment is per-
formed by a Service Agent.
Drain fuel and refill with a fresh fuel mix.
Remix the fuel at the correct ratio 40:1.
Use fresh fuel and the correct 2-stroke oil
mix ratio.
Clean air filter (13).
Refer to page 21 for adjustment, however,
It is recommended this adjustment is
performed by a Service Agent.
Release chain brake (12).
Re-tension the chain (19).
Refer to "Assembly / Installation of the
Guide Bar and Chain" section in manual.
Inspect guide bar (18) and chain (19)
for damage.
Check oil tank (6) is filled with oil.
Check oil hole in the guide bar (18) is not
clogged. Remove and clean.
Take chainsaw to Service Agent and DO
NOT continue use
e-mail: help@powertoolsupport.com
MODEL: №. YR-CS4500S • 04/2016 • 51488
Warranty
33