Assigning Address To Indoor Unit - Samsung FH052EAMT Installation Manual

Assigning address to indoor unit

16
E-
1 Before installing the indoor unit, assign an address to the indoor unit
according to the air conditioning system plan.
2 The address of the indoor unit is assigned by adjusting MAIN(SW01) and
RMC(SW02) rotary switches.
SW05 SW04 SW03
K9 K10 K11K12 K5 K6 K7 K8 K1 K2 K3 K4
The MAIN address is for communication between the indoor unit and the outdoor
3
unit. Therefore, you must set it to operate the air conditioner properly.
4 It is required to set the RMC address if you install the wired remote controller
and/or the centralized controller.
5 If you install optional accessories such as the wired remote controller, centralized
controller, etc. see an appropriate installation manual.
6 If an optional accessory is not installed, you do not have to set the RMC
address. However, adjust K1 and K2 switches of the SW03 DIP switch to
"ON" position in this case.
7 Set the MAIN address by adjusting the rotary switch(SW01) from 0 to F. Each
indoor unit connected to the same outdoor unit must have different address.
i. e. If an indoor unit does not have an optional accessory
and its MAIN address is "0"
SW05 SW04
K9 K10 K11K12 K5 K6 K7 K8
SW02 SW01
MAIN
RMC
SW03
SW02 SW01
K1 K2 K3 K4
RMC MAIN