Measuring The Ring-Gear-To-Stopper-Bolt Clearance; Adjusting The Ring-Gear-To-Stopper-Bolt Clearance - Yamaha FJR1300A Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Final gear backlash is in-
Thinner shim
creased.
Final gear backlash is de-
Thicker shim
creased.
b. If it is necessary to increase the final gear
backlash by more than 0.2 mm, reduce the
thrust washer thickness by 0.2 mm for every
0.2 mm increase of ring gear shim thickness.
c. If it is necessary to reduce the final gear back-
lash by more than 0.2 mm, increase the
thrust washer thickness by 0.2 mm for every
0.2 mm decrease of ring gear shim thickness.
Ring gear shims
Thickness (mm)
0.25 0.30 0.40 0.50
Thrust washers
Thickness (mm)
1.2 1.4 1.6 1.8 2.0
L LLL L LLL L L LLL L
EAS23600
MEASURING THE RING-GEAR-TO-
STOPPER-BOLT CLEARANCE
1. Remove:
• Ring gear bearing housing
(along with the ring gear)
Refer to "ADJUSTING THE FINAL GEAR
BACKLASH" on page 4-93.
2. Measure:
• Ring-gear-to-stopper-bolt clearance "a"
Out of specification → Adjust.
Ring-gear-to-stopper-bolt clear-
ance
0.30–0.60 mm (0.0118–0.0236 in)
email: info@motomatrix.co.uk
L LLL L L LLL L L LLL L LLL
1. Stopper bolt
2. Ring gear
3. Install:
• Ring gear bearing housing
(along with the ring gear)
EAS23610
ADJUSTING THE RING-GEAR-TO-
STOPPER-BOLT CLEARANCE
1. Remove:
• Ring gear "1"
• Stopper bolt "2"
• Stopper bolt shim(s) "3"
• Ring gear bearing housing "4"
2. Select:
• Stopper bolt shim(s)
Stopper bolt shims
Thickness (mm)
0.15 0.20
3. Install:
• Ring gear bearing housing "1"
• Stopper bolt shim(s) "2"
• Stopper bolt "3"
• Ring gear "4"
Stopper bolt
9 Nm (0.9 m·kg, 6.5 ft·lb)
ECA14320
CAUTION:
• The stopper bolt has left-hand threads. To
tighten the stopper bolt, turn it counter-
clockwise.
4-94
SHAFT DRIVE