Warnings; Hook-Up Information - Mr. Heater MH24T Operating Instructions And Owner's Manual

HOOK-UP INFORMATION

1.1 Heater model MH24T and MH24TS are packaged completely
assembled. Propane cylinders are not included with heater
models.
1.2 Remove heater assembly from carton.
1.3 Place the slots of the black collar mounting bracket assembly
onto the collar of the bulk tank (see Fig. 1)
CAUTION:
BE SURE THE LOCKING KNOB ON THE COLLAR MOUNT-
ING BRACKET ASSEMBLY IS OUTSIDE THE COLLAR ON
THE BULK TANK. Tighten the black knob against collar of
tank.
1.4
mounting bracket assembly with the three #6-32x1/2 screws
and #6-32 Keps hex nuts. Be sure screws and nuts are secure
and tight.
1.5 Make sure tank valve is in "OFF" position (clockwise).
LOCKING
KNOB
MODEL MH24T
Mr. Heater | Gas-Fired Infra-Red Portable Heater
REFLECTOR
HOSE ASSEMBLY
REGULATOR
KNOB
TIGHTEN
POL NUT
LP CYLINDER
COLLAR
MOUNTING BRACKET
Figure 1
MODEL MH24TS
3
1.6 Make sure regulator knob is in "OFF" position by turning knob
clockwise to off.
1.7
turning counterclockwise; then with a 7/8" open end wrench
tighten the POL fitting, hard.
1.8 Always connect the heater to bulk tank in the outdoors or in a
well ventilated area. NEVER connect heater to bulk tank near
an open flame.
1.9 Use only LP-gas cylinders constructed for use with propane only
LP-gas cylinders of the U.S. Department of Transportation (DOT
Spec. 39).
1.10 Read pages 3 and 4 before lighting heater.
WARNING
Never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
Operating Instructions and Owner's Manual
SPARKLITE IGNITER
SAFETY
SHUT OFF VALVE
TANK VALVE